EKWB EK-Quantum Inertia D5 PWM D-RGB Plexi

EKWB EK-Quantum Inertia D5 PWM D-RGB Plexi

EKWB EK-Quantum Inertia D5 PWM D-RGB Plexi comes with Electronically commuted spherical motor. This EKWB EK-Quantum Inertia D5 PWM D-RGB Plexi featured with Rated voltage: 12V DC, Power consumption: 23W, Maximum pressure head: 3.9m, Maximum flow: 1500L/h and Maximum system temperature: 60°C. This Mpotor built in Stainless steel, PPS-GF40, EPDM O-rings, Aluminium oxide, hard coal Materials. Here, 4-Pin Molex 50cm cable length Power connector, Signal cable: 4-Pin PWM FAN connector 60cm cable length, D-RGB cable length: 50cm and D-RGB connector standard 3-pin (+5V, Data, Blocked, Ground). This pump is compatible for PC and other electronics water cooling and also equipped with an electronically commutated spherical motor. In a pump with a spherical motor, the only moving part is a spherically shaped rotor which in this pump is held in place by a bearing ball made of ultra-hard and wear-resistant ceramic. It is rated for 50.000 hrs MTBF at 25°C ambient. This D-RGB Plexi also featured with PWM duty cycle: ~ 20-100%, Default behavior: Runs at 100% duty cycle when no PWM feedback signal is present. The new Quantum Inertia D5 pump volute/body system features a fully rounded design thus offering greater usability, allowing installation at any angle within 360° of rotation. In this EKWB EK-Quantum Inertia D5 PWM D-RGB Plexi, It has a special rubber shock absorber is used to de-couple the main pump body from the mounting clip for silent operation, free of vibration-induced noise. Additionally, horizontal and vertical positioning is supported for easier tube routing possibilities. This new EKWB EK-Quantum Inertia D5 PWM D-RGB Plexi has 02 years warranty.